Tip
These settings
appear in the
QoS section of the
Summary
tab.
Use this task to configure the settings for a new port, on the Transmission Settings
tab.
-
Type the maximum transmission
unit value for MTU
Settings, to define the largest packet size that can be
transmitted through your system.
-
For Flow Control,
select how to manage the receive transmission speed, which enables a feedback
mechanism between a transmitting port and the receiving port on the switch.
-
For Transmission
Type, select Auto,
Half-Duplex, or
Full-Duplex.
Auto
causes the switch to negotiate the best possible duplex mode possible with the
connected device. Full-Duplex forces the switch to
communicate with the connected device using full-duplex communication.
Half-Duplex forces the switch to use half-duplex
communication.
-
Select the
Speed the switch port uses to communicate with the
connected device.
-
Select LLDP
Transmit to enable the switch to transmit LLDPDU frames.
-
Select LLDP
Receive to enable the switch to receive LLDPDU frames.
-
Select Client Reporting to display learned switch port
client MAC addresses on ExtremeCloud IQ monitoring screens.
When client reporting is
disabled, client MAC addresses are not displayed. It is disabled when
CDP Receive is turned off.
-
Select the NEXT, or select
the STP tab, and continue configuring the port.
